16Mhz
Crystal Fuse Bit Configuration
Below is a screenshot of how to configure the fusebits for a ATmega32 with a 16Mhz external crystal on PP2000. The options used are those described in previous sections and highlighted in green.
As it turns out for my development system with a 16Mhz external crystal, there should be only two boxes checked, BOOTSZ1 and BOOTSZ0. The rest of the boxes should be unchecked, to obtain the settings as described and highlighted in green in previous sections.
At the bottom of this page there is a screenshot of what it should look like.
Below is a screenshot of how to configure the fusebits for a ATmega32 with a 16Mhz external crystal on PP2000. The options used are those described in previous sections and highlighted in green.
As it turns out for my development system with a 16Mhz external crystal, there should be only two boxes checked, BOOTSZ1 and BOOTSZ0. The rest of the boxes should be unchecked, to obtain the settings as described and highlighted in green in previous sections.
At the bottom of this page there is a screenshot of what it should look like.
Introduction
Using PP
Default Settings
Clock Selection
CKOPT
SUT
JTAGEN
16Mhz Crystal
Common Mistakes
Chip Recovery
