Sony SmartWatch 2 Battery Replacement
The SmartWatch 2 (SW2) battery replacement first involves disassembling the watch. It will also involve desoldering the two battery wires. Inside, there is a 3.7 V 225 mAh capacity Li-ion rechargeable battery with the following written upon it.
- AHB412033PS
- V2.0
- 3.7 V
- 225 mAh
- 1ICP5/20/33
- Synergy
- Li-ion
- +AHB412033T
- 4313083-0340
- 0.9 Wh
Some of the most important parameters are the voltage and approximate dimensions (33 mm x 19.5 mm x 3.5 mm). I could not find a cheap original replacement battery but managed to find a large number of generic 3.7 V batteries on the auction site. These generic batteries are usually used in Smartwatch clones and I managed to find one that was the correct voltage and small enough to fit. If it arrives from China, and if it works, then I shall write about it here.
As you can see, there is double-sided tape to secure the battery in place. I gently eased the battery out with minimal force.
This Article Continues...
Sony SmartWatch 2Disassembly
Battery Replacement
Wiring